Diagram Part List

Motor, Resistance

Motor, Resistance - Product Image

Currently In Stock! (Explain)

Resistance motor.

NOTE: The white cam will have to be adjusted during install because each machine may have minor differences. The center phillips screw in the cam can be loosened to adjust the cam position.

Volume Discounts: (How do I qualify?)
Level 1	Level 2	Level 3
$94.55	$92.56	$89.58

* Images may not be identical to part.

#	Part Name (Click to view)	BOM Qty
2	REAR STABILIZER	1
3	RAMP	1
4	NLA UPRIGHT	1
5	Screw	8
6	Stabilizer, Front	1
7A	Console, Display	1
7B	CNSL REPROGRAMMING MODULE	1
8	LEFT HANDLEBAR	1
9	RIGHT HANDLEBAR	1
10	RAMP COVER	1
11	INCLINE MOTOR	1
12	INCLINE MOTOR ARM	1
13	Arm, Ramp	1
14	RAMP ROLLER	1
15	REAR STABILIZER COVER	1
16A	NLA Bracket, Track, Left	1
16B	NLA RIGHT TRACK	1
16C	TRACK TAPE	2
17	LARGE FRAME BUSHING	2
18	Crank, Axle	1
19	Pulley assembly	1
20	CRANK ARM	2
21	Screw	4
22	Bracket, Idler	1
23	M10 X 15MM SCREW	1
24	M10 X 95MM BOLT	1
25	Motor, Resistance	1
26	Screw	1
27	Fastener, Standoff	4
28A	EDDY MECHANISM	1
28B	Adjuster	1
29	MECHANISM AXLE	1
30	STABILIZER CAP	4
31	Power supply	1
32	POWER SWITCH	1
33	Foot, Leveler	2
34	Wheel	2
35	Axle, Pivot	1
36	Bushing	2
37	ACCESSORY TRAY	1
38	Speed sensor	1
39	Retainer Clamp	1
40	Bearing, Sealed	2
41	MECHANISM SPACER	2
42	Sleeve	1
43	Magnet	2
44	LEFT PEDAL ARM	1
45	LEFT ROLLER ARM	1
46	LEFT UPPER BODY LEG	1
47	Arm, Upper Body, Left	1
48	Pin, Cotter	1
49	Pedal, Left	1
50	Nut, Locking	6
51	NLA Wheel	2
52	PEDAL ARM REAR CAP	2
53	Cover, Axle, Large	4
54	Washer, Wave	2
55	Cover, Axle, Small	2
56	Bushing	4
57	Bearing, Arm	8
58	RIGHT PEDAL ARM	1
59	RIGHT ROLLER ARM	1
60	Handlebar, Upper, Right	1
61	NLA RIGHT UPPER BODY ARM	1
62	HANDGRIP	2
63A	Wire Harness, HR, Right	1
63B	Wire Harness, Pulse, Left	1
63C	SENSOR ASSEMBLY	2
64	Axle	2
65	RT UPR BODY ARM FRONT CVR	1
66	Cover, Arm, Upper, Right, Rear	1
67	LT UPR BODY ARM FRONT CVR	1
68	LT UPR BODY ARM REAR CVR	1
69	Cover, Outer, Body Leg, Upper, Right	1
70	Cover, Side, Left	1
71	DISC	2
72	LT UPR BODY LEG INNER CVR	1
73	LEFT SHIELD	1
74	Cover, Side Shield, Right	1
75	SHIELD COVER	1
76	LEFT PEDAL ARM SIDE CAP	1
77	Spacer, Axle	4
78	Retainer, Key	2
79	FRONT CONSOLE COVER	1
80	REAR CONSOLE COVER	1
81A	REAR UPRIGHT COVER	1
81B	Receiver, Chest Pulse	1
82A	Screw	10
82B	Screw, Shoulder	2
83	RT UPR BODY LEG INNER CVR	1
84A	M10 WASHER, LIFT ARM	1
84B	Washer	2
85	Screw	2
86	Screw	2
87	Cap, Side, Arm, Pedal, Right	1
88	Screw	1
89	Bolt, Idler	1
90	Washer, Flat	3
91	Screw	1
92	Screw	2
93	Screw	18
94	Washer	2
95	Screw	6
96	Screw	8
97	Washer	10
98	Retainer	2
99	Screw	4
100	Bearing	4
101	Screw	35
102A	Nut, Locking	2
102B	Nut, Nylock Hex	8
103	Screw	8
104	Bolt	4
105	Washer, Locking	8
106	Fastener	3
107	Screw	1
108	Screw	2
109	Screw	2
110	LOWER WIRE	1
111	20" RESISTANCE MTR WIRE	1
112	Plate, Power Cord	1
113	Belt, Drive	1
114	M4 X 42MM SCREW	4
115	Bracket, Control Board	1
116	DISC RING	2
117	FRONT UPRIGHT COVER	1
118	SHIELD COVER CAP	1
119	Power cord, 110V	1
120	RAMP AXLE	1
121	Bushing, Axle	6
122	CLEVIS PIN	1
123	Spacer	1
124	M4 X 19MM SCREW	2
125	Bumper, Leveler	2
126	Pedal, Right	1
127	RIGHT PEDAL INSERT	2
128	EXTENSION WIRE	1
	15" WIRE HRNS, LIFT MTR	1
	Wire harness	1
	30" BLUE WIRE, F/F	1
	26" WHITE WIRE, M/F	1
	Wire Tie	1
	Cable Tie, Mounting	2
	Clamp, Cable, Long	6
	Cable Tie	2
	Grommet, Rectangle	1
	M4.2 X 12 PDL INSERT SCRW	14
	Grease	3
	Wrench	2
	Wrench, allen	1
	DECAL, LEFT RAMP ANGLE	1
	DECAL, RIGHT RAMP ANGLE	1
	DECAL, GENERAL WARNING	1
	Manual, Owner's	1
	Wire Harness	1
	Tool, Pliers, Snap ring	1
	NLA Mat, Floor	1
	OPTIONAL CHEST PULSE	1
	NLA Accessory Kit, IFIT WIFI	1

E7.7 - NTEL081121 Exploded Diagrams

Base Frame Assembly & Motor
Console & Covers
Pedal Assembly

Motor, Resistance

$96.54 / each

E7.7 - NTEL081121 Exploded Diagrams

CLICK HERE TO BREAK OUT OF THIS FRAME AND SHOW THE WHOLE PAGE